S10/FM12 User Guide and Care Instructions

User Guide

To prepare the mask for wearing, use the anti-fog spray to prevent misting up if not already applied. Remove the masturbator from its container and insert it into the front of the mask. The notch just behind the front of the masturbator secures it to the rim on the inside of the masturbator holder. To ensure it is sitting properly, give the mask a gentle shake which should help seat the masturbator correctly. If desired, it is often easier to don the mask before attaching a filter canister.

To don the mask, hook your thumbs through the bottom harness straps, place your chin in the chin cup and pull the harness over down the head. Ensure the straps are sitting smooth and flat against the head and that the seals around the mask are flush with the face. To test if the fit is correct, with the cap screwed on, half empty your lungs, place the palm of the hand over the 40mm NATO hose port or inlet for any attached filter canister, and gently attempt to breathe in. If the mask is sucked toward the face then the mask is fitting correctly. If air is leaking in around the mask seal then adjust the position of the mask on the face or adjust the straps as required. To remove the mask, grasp the bottom of the front of the mask and lift it up and back over the head.

To use the mask, use water based lubricant on the inside of the masturbator and insertable toy before inserting it into the masturbator. Damage to the masturbator can occur easily if insufficient lube is used. Once the toy has been inserted the cap can be screwed onto the front of the mask, securing the toy in place. This can easily be removed to release the toy from the masturbator.

Care Instructions

To clean, remove the inner oronasal mask, masturbator, and toy to clean separately. Mild soap and warm water can be used to clean the masks and dildo. The masturbator, according to the manufacturer, can be cleaned with water and, optionally, masturbator cleaner. Air dry all parts separately. Water can easily be trapped in the seals of the gas mask, make sure as much water is removed as possible before leaving to air dry. Water droplets on the lenses can be dried with a towel to prevent residue drying on them. A small amount of isopropyl alcohol can be used to further sterilise surfaces on the dildo and gas mask. Then a very small amount of silicone can be applied to the outer rubber surfaces of the gas mask with a damp cloth which will shine the rubber and keep it in good condition. Keep all parts away from oils and clean thoroughly if oils come into contact with any parts. The anti-fog spray can be reapplied at this point in accordance with its included instructions. To re-attach the inner oronasal mask, gently stretch the rubber ring around the rim on the inside of the masturbator holder, ensuring the orientation is correct. The canvas haversack can be hand washed with soap and cold water, it is not suitable for machine washing. Be very careful with the painted areas of canvas as warm or hot water and scrubbing action may result in the paint being removed.

To store the mask, return the masturbator and dildo to their respective containers, keep all parts at room temperature and out of direct sunlight. The haversack may be used for storage.